Filter interviews by
Clear (1)
I applied via Naukri.com and was interviewed in Dec 2022. There were 3 interview rounds.
A 3-phase 4 wire system is a type of electrical system commonly used for power distribution.
Consists of three conductors carrying alternating current at the same frequency, with a fourth neutral conductor
Provides a more balanced and efficient power distribution compared to single-phase systems
Commonly used in industrial and commercial applications for higher power requirements
Example: Used in large factories, office bu
A characteristic of digital signal is that it is discrete and represented by binary numbers.
Digital signals are represented by discrete values
Digital signals are represented by binary numbers (0s and 1s)
Digital signals are less susceptible to noise compared to analog signals
Norton representation is preferred when the load impedance is known and fixed.
Norton representation is preferred when the load impedance is known and fixed, as it simplifies calculations.
Thevenin representation is preferred when the load impedance is unknown or variable.
Norton equivalent circuits are easier to analyze in terms of current flow and power calculations.
Thevenin equivalent circuits are easier to analyze in
Diploma in electrical engineering
Top trending discussions
posted on 30 Sep 2022
I applied via LinkedIn and was interviewed before Sep 2021. There were 2 interview rounds.
I was interviewed in Aug 2023.
Time constant of an RC circuit is the time taken for the voltage across the capacitor to reach approximately 63.2% of its final value.
Time constant (τ) is calculated as the product of resistance (R) and capacitance (C) in the circuit, τ = R * C.
It represents the rate at which the capacitor charges or discharges in response to a step change in voltage.
A smaller time constant indicates a faster response of the circuit, w...
Comparators are electronic circuits that compare two voltages and output a digital signal based on the comparison. Band pass filter circuit allows only a certain range of frequencies to pass through.
Comparators are used in applications such as voltage level detection, waveform shaping, and pulse width modulation.
They have two input terminals for the voltages to be compared and one output terminal for the digital signal...
posted on 22 Jan 2021
FMEA is a risk assessment tool used to identify and mitigate potential failures. CP and CPK are statistical measures of process capability.
FMEA stands for Failure Mode and Effects Analysis
It is used to identify potential failures in a process or product
CP and CPK are statistical measures of process capability
They are used to determine if a process is capable of producing products within specification limits
CPK is a mor...
Industry growth in QMS can be achieved by implementing efficient quality management systems and promoting their benefits.
Developing and implementing effective QMS policies and procedures
Providing training and education to employees on QMS
Encouraging continuous improvement and innovation in QMS
Promoting the benefits of QMS to customers and stakeholders
Ensuring compliance with industry standards and regulations
Collaborat...
SOC refers to the state of charge of a battery, SOH refers to the state of health, pre-charge is the initial charging process, and cell chemistry refers to the type of chemicals used in the battery.
SOC is the amount of charge remaining in a battery, expressed as a percentage of its maximum capacity.
SOH is a measure of a battery's overall health and its ability to hold a charge over time.
Pre-charge is the initial chargi...
posted on 11 May 2024
I applied via Approached by Company and was interviewed before May 2023. There were 2 interview rounds.
posted on 24 May 2024
I applied via Approached by Company and was interviewed before May 2023. There were 2 interview rounds.
Number coding blood relation decode number
posted on 24 Apr 2021
I applied via Naukri.com and was interviewed before Apr 2020. There were 3 interview rounds.
based on 2 interviews
2 Interview rounds
based on 6 reviews
Rating in categories
Engineer
109
salaries
| ₹0 L/yr - ₹0 L/yr |
Senior Engineer
105
salaries
| ₹0 L/yr - ₹0 L/yr |
Service Engineer
52
salaries
| ₹0 L/yr - ₹0 L/yr |
Design Engineer
44
salaries
| ₹0 L/yr - ₹0 L/yr |
Production Engineer
42
salaries
| ₹0 L/yr - ₹0 L/yr |
Exide Industries
Su-Kam Power Systems
Amara Raja Energy & Mobility
Luminous Power Technologies