Filter interviews by
I applied via Walk-in and was interviewed in Nov 2024. There were 2 interview rounds.
Folks,
Prepare the below topics very well.
1. Engineering mechanics
2. GD and T
3. Strength of materials
4. Manufacturing process
5. Tolerance stack up analysis
6. Engineering drawing
I had prepared them but still unable to clear the paper cause questions were tricky enough to answer.
I hope this helps you better for practice.
All the best “Brothers, Sister and Friends”.
Top trending discussions
I applied via Walk-in and was interviewed in Jan 2020. There were 5 interview rounds.
I applied via Campus Placement
I applied via Approached by Company and was interviewed in Jan 2023. There were 3 interview rounds.
posted on 28 May 2022
I applied via Company Website and was interviewed in Nov 2021. There was 1 interview round.
posted on 18 May 2024
posted on 10 Jan 2023
I applied via Recruitment Consulltant and was interviewed before Jan 2022. There were 4 interview rounds.
Technical and aptitude Questions
I applied via Campus Placement and was interviewed in May 2024. There were 2 interview rounds.
1 hr and various apti topics
Gas turbine engines work by compressing air, mixing it with fuel, igniting the mixture, and using the hot exhaust gases to spin a turbine.
Air is drawn into the engine and compressed by a compressor
Fuel is injected and mixed with the compressed air
The mixture is ignited, causing a rapid expansion of gases
The hot exhaust gases are used to spin a turbine, which drives the compressor and generates thrust
Examples: Jet engin
Factor of safety is a design parameter that accounts for uncertainties in material properties and loading conditions.
Factor of safety is the ratio of the maximum stress a material can withstand to the maximum stress it is subjected to in a given application.
It ensures that the structure or component will not fail under normal operating conditions.
Higher factor of safety values indicate a more conservative design approa...
Tolerance refers to the allowable variation in dimensions or properties of a part or product.
Tolerance is important in engineering to ensure proper fit and function of components.
It is typically specified as a range of acceptable values, such as +/- 0.1mm.
Tolerance can be applied to dimensions, material properties, surface finish, etc.
For example, a hole may have a tolerance of +/- 0.05mm to allow for proper alignment
I applied via Company Website and was interviewed in Jan 2023. There were 3 interview rounds.
based on 1 interview
Interview experience
Lead Engineer
618
salaries
| ₹6 L/yr - ₹22.2 L/yr |
Senior Leader Engineer
440
salaries
| ₹9.8 L/yr - ₹30 L/yr |
Associate Engineer
431
salaries
| ₹4.9 L/yr - ₹12.5 L/yr |
Design Engineer
235
salaries
| ₹4.1 L/yr - ₹13 L/yr |
Lead Software Engineer
197
salaries
| ₹6.2 L/yr - ₹19.2 L/yr |
Indian Army
Indian Air Force
Tata Advanced Systems
Hindustan Aeronautics