Walk-in at Mumbai For Piping Stress Engineer

Responsibilities:

• Hands on experience in CAESAR II / SST Caepipe / Bentely Autopipe / Lisega LICAD
• Knowledge of material and piping codes / standards n as per ASME Codes & Standards (ASME 31.3 & 31.1, NEMA SM 23) in STEEL piping system
• Design experience in piping, pipe support and pipe layout
• Experience in visual clearances of Non-critical Piping systems, Span calculations, Expansion loop calculations, Trunnion qualification calculations.
• Experience in preparing loading data for other engineering information such as civil and mechanical.
• Prepare Stress critical P&ID, Critical Line List, piping stress isometrics, piping stress layouts.
• Preparation & Checking of Analysis reports as per client requirements.
• Stress analysis for entire piping network, to qualify the stress in pipes & fitting by recommending reinforcement & additional supports are required and marking the same in the corresponding isometric drawing.
• Experience in visual clearances of Non-critical Piping systems, Span calculations, Expansion loop calculations, Trunnion qualification calculations.
• Experience in preparing loading data for other engineering information such as civil and mechanical.
• Review of Piping ISO, Feasibility check of Layouts, Pipe routing and Line No. as per P & IDs.
• Adequate experience in Piping layout, Design/selection of Supports, Hanger selection etc.
• Support selection & developing special piping support arrangements based on feasibility and judging requirements.
• Preparing Stress critical line list.
• Carrying out the Preliminary Piping stress analysis and providing support locations and loads to
• structural department.
• Carrying out the Piping stress analysis for the critical piping with CAESAR II software.
• Checking compensation leg required and supporting requirement for the non-critical lines with manual calculations using in house excel sheets and span charts.
• Preparing specifications for spring hangers, expansion joints as per stress analysis.
• Selecting primary and secondary supports based on the client approval vendor catalogues.
• Preparing stress analysis report for client submission.
• Preparing piping loads to civil design.
• Coordinate with Process, Civil/Structural, Mechanical, Electrical and Instrumentation groups to ensure design suits all these depts.
• Collaborate with Piping and Support Engineers for optimal design.
• Do vendor drawing reviews and provide comments if any
• Have a cooperative working attitude.

Must to have experience in Below Softwares:

• CAESAR II
• SST Caepipe
• Bentely Autopipe
• Lisega LICAD.