Supershakti Metaliks Diploma Trainee Engineer Interview Questions and Answers for Freshers

Q1. All about area related work
Add your answer

Q1. Package finalizing and house allotment process
Add your answer

Very good

Q1. It was difficult but if you keep communicating good it will be easier
Add your answer
Q2. Question related to technology and development
Add your answer

Q1. Working principle of ngr
Ans. 
NGR (Next Generation Routing) is a networking technology that dynamically routes traffic based on real-time network conditions.
• NGR uses machine learning algorithms to analyze network data and make routing decisions.

• It can optimize traffic flow by selecting the best path based on factors like latency, bandwidth, and congestion.

• NGR can adapt to changing network conditions in real-time, improving performance and reliabili...read more
Answered by AI
Add your answer

Q1. Working principle of Ngr
Ans. 
Ngr stands for Next Generation Routing. It is a routing protocol used in networking to determine the best path for data packets to travel.
• Ngr uses advanced algorithms to calculate the most efficient route for data packets.

• It takes into account factors such as network congestion, latency, and available bandwidth.

• Ngr helps in optimizing network performance and reducing packet loss.

• Examples of Ngr protocols include OSPF (...read more
Answered by AI
Add your answer

Q1. What is the heat treatment
Ans. 
Heat treatment is a process used to alter the physical and sometimes chemical properties of a material through controlled heating and cooling.
• Heat treatment involves heating a material to a specific temperature, holding it at that temperature for a certain amount of time, and then cooling it at a controlled rate.

• The purpose of heat treatment is to improve the material's hardness, strength, toughness, ductility, and oth...read more
Answered by AI
Add your answer

Q1. What is the magnetic particle test procedure
Ans. 
Magnetic particle test is a non-destructive testing method used to detect surface and near-surface flaws in ferromagnetic materials.
• The test involves magnetizing the component, applying magnetic particles to the surface, and inspecting for indications of defects.

• Defects such as cracks, laps, seams, and inclusions can be detected using this method.

• The test can be performed using either dry magnetic powder or wet fluores...read more
Answered by AI
Add your answer

Good basics aptitude questions simple interest general knowledge math general reasoning English grammar reading

Q1. What is your favourite subject
Add your answer
Q2. What is ac current Describe your project
Add your answer

Q1. Metallurgy Engg related
Add your answer
Q2. Steel melting related
Add your answer

Q1. Type of ac motor
Ans. 
AC motors are classified into two main types: induction motors and synchronous motors.
• Induction motors: most commonly used type, works on the principle of electromagnetic induction, no external power supply needed for rotor

• Synchronous motors: rotor rotates at the same speed as the rotating magnetic field, requires external power supply for rotor

• Examples: Induction motors - squirrel cage motor, wound rotor motor; Synchr...read more
Answered by AI
Add your answer
Q2. What is Ohms law
Ans. 
Ohm's law states that the current flowing through a conductor is directly proportional to the voltage across it, and inversely proportional to its resistance.
• Ohm's law is represented by the formula V = IR, where V is voltage, I is current, and R is resistance.

• It helps in calculating the current flowing through a circuit when the voltage and resistance are known.

• It also helps in determining the resistance of a component...read more
Answered by AI
Add your answer