Century Crane Engineers Fabrication Engineer Interview Questions and Answers for Experienced

About your qualification and knowledge.

Q1. Talk about your resume showin the experience.
Add your answer
Q2. Tell me about yourself and general .
Add your answer
Q3. Knowledge of experience
Add your answer

Q1. Taranformer rating ....... KVA MVA HZ
Add your answer
Q2. Ohm low ...........
Add your answer
Q3. Current of unit .......
Ans. 
The question is asking about the current of a unit.
• The current of a unit refers to the amount of electric current flowing through a specific unit or device.

• It is typically measured in amperes (A) or milliamperes (mA).

• The current of a unit can vary depending on the specific device or circuit being discussed.

• For example, the current of a unit could refer to the current flowing through a resistor, a transistor, or a motor...read more
Answered by AI
Add your answer
Q4. Transformers rating in KVA
Ans. 
Transformers are rated in KVA (kilovolt-amperes) to indicate their power capacity.
• KVA stands for kilovolt-amperes, which is a unit of apparent power.

• The KVA rating of a transformer indicates the maximum amount of power it can handle.

• Transformers are available in various KVA ratings to suit different power requirements.

• Higher KVA ratings indicate higher power capacity.

• For example, a transformer with a 100 KVA rating can
Answered by AI
Add your answer
Q5. What is loop law?
Ans. 
Loop law, also known as Kirchhoff's voltage law, states that the sum of the voltages in any closed loop in a circuit is zero.
• Loop law is a fundamental principle in electrical engineering.

• It is also known as Kirchhoff's voltage law (KVL).

• According to loop law, the algebraic sum of the potential differences (voltages) around any closed loop in a circuit is always zero.

• It is based on the principle of conservation of energ...read more
Answered by AI
Add your answer

Q1. Technical field related questions asked
Add your answer

Q1. Asking family background , previous company details
Add your answer

Q1. In Final round company M.D asked questions
Add your answer

Personality, Good communication skill required

Q1. What is SPC, CP&CPK, CAPA, 7QC TOOL, Basic of GD&T.
Ans. 
SPC, CP&CPK, CAPA, 7QC TOOL, Basic of GD&T are quality control tools used in manufacturing and engineering.
• SPC (Statistical Process Control) is a method of monitoring and controlling a process to ensure it operates within its specified limits.

• CP (Process Capability) and CPK (Process Capability Index) are measures of a process's ability to produce parts within specification limits.

• CAPA (Corrective and Preventive Action)...read more
Answered by AI
Add your answer

Q1. What is MSA, Kaizen, why-why analysis,
Ans. 
MSA is Measurement System Analysis, Kaizen is continuous improvement, Why-Why analysis is a root cause analysis technique.
• MSA is used to evaluate the measurement system's ability to accurately and precisely measure a product or process.

• Kaizen is a Japanese term for continuous improvement, it involves making small incremental changes to improve efficiency and quality.

• Why-Why analysis is a root cause analysis technique u...read more
Answered by AI
Add your answer