Filter interviews by
I applied via Job Portal and was interviewed in Dec 2023. There were 2 interview rounds.
Top trending discussions
I applied via Campus Placement and was interviewed in Apr 2023. There were 3 interview rounds.
I was interviewed before Dec 2023.
Guage handling and instrument
Height check drawing reading
Yes, I have experience handling Vernier and micrometer.
I have used Vernier and micrometer in my previous job as a quality inspector.
I am familiar with the proper use and calibration of these tools.
I understand the importance of accurate measurements in ensuring product quality.
I am willing to undergo additional training if necessary.
The least count of a micrometer is the smallest measurement that can be read on the scale.
The least count of a micrometer is typically 0.01 mm or 0.001 mm.
It depends on the type of micrometer being used.
For example, an outside micrometer typically has a least count of 0.01 mm, while an inside micrometer may have a least count of 0.001 mm.
The least count is important for accurately measuring small distances or dimension
I applied via Recruitment Consulltant and was interviewed in Oct 2021. There was 1 interview round.
based on 1 interview
Interview experience
Senior Engineer
139
salaries
| ₹3.9 L/yr - ₹7.5 L/yr |
Engineer
105
salaries
| ₹2.5 L/yr - ₹6.7 L/yr |
Quality Engineer
93
salaries
| ₹1.5 L/yr - ₹4.8 L/yr |
Junior Engineer
91
salaries
| ₹1.7 L/yr - ₹4 L/yr |
Assistant Manager
89
salaries
| ₹5 L/yr - ₹9.2 L/yr |
Bharat Forge
Tata Technologies
Tech Mahindra
Larsen & Toubro Limited