Venture Offshore Info Matrix Interview Questions and Answers

Commissioning of a sub sea PLEM to CRP #1500 class shut down valve instrumentation.

• Ensure proper installation of the valve and its associated instrumentation.

• Perform loop checks and functional tests to verify proper operation.

• Calibrate and configure the valve instrumentation according to the control system requirements.

• Verify the valve's response to control signals and emergency shutdown signals.

• Perform a final inspection and documentation of the commissioning process.

The salt content on the blasted surface in onshore areas is determined through testing and analysis.

• Salt content on the blasted surface can be measured using various methods such as conductivity meters, chloride ion tests, or salt spray tests.

• The salt content is usually expressed in terms of parts per million (ppm) or milligrams per square meter (mg/m²).

• High salt content on the blasted surface can lead to corrosion and affect the quality and durability of coatings or structur...read more

To check the verticality of a column, use a plumb bob or laser level. Acceptance criteria: deviation within a specified tolerance.

• Use a plumb bob or laser level to check if the column is perfectly vertical.

• Ensure the plumb bob or laser level is aligned with the centerline of the column.

• Measure the deviation from the vertical position and compare it to the specified tolerance.

• Acceptance criteria may vary depending on the project or industry standards.

I will ensure smooth start up for plant by conducting thorough testing, creating detailed procedures, and training the operators.

• Conduct thorough testing of all equipment and systems before start up

• Create detailed start up procedures and checklists

• Train operators on the procedures and ensure they understand their roles and responsibilities

• Perform simulations and drills to identify and address any potential issues

• Collaborate with other departments and stakeholders to ensure a ...read more

The electrode used for A36 steel is typically E7018.

• E7018 electrode is commonly used for welding A36 steel due to its high tensile strength and excellent weldability.

• It provides good penetration and produces strong, clean welds.

• Other suitable electrodes for A36 steel include E6010, E6011, and E6013.

• The choice of electrode depends on the specific welding requirements and conditions.

MSDS of xylene and acetone and pour point definition.

• MSDS of xylene and acetone provide information on their physical and chemical properties, health hazards, and safety precautions.

• Pour point is the lowest temperature at which a liquid will flow.

• Xylene is a colorless, flammable liquid used as a solvent and in the production of plastics, synthetic fibers, and dyes.

• Acetone is a colorless, volatile liquid used as a solvent and in the production of chemicals, plastics, and pharm...read more