Embedded Electronics Engineer

Responsibilities:
1. Designing and development of new hardware functional system for multiple products.
2. Collaborate with with the embedded software development team for Electronics hardware/ firmware co-design and system performance requirement translating to design implementation ; optimization.
3. Ability to synthesize user and technical performance hardware requirements and develop
appropriate solutions.
4. Electronic component and circuit analysis to design functional sub-system by simulation and physical implementation.

Requirements & Skills:
Must to have:
1. 2 years to 4+ years of experience in low-power circuit design, system bring-up, engineering-build integration and debug.
2. 2 years to 4+ years of experience driving design development from component selection,
schematic capture, PCB layout and routing, Component foot-print for the product Electronics BoM through assembly.
3. 3+ of experience in Multi-layer, mixed-signal board-level design in Altium/ Eagle.
4. Experience of power topology: DC-DC, Flyback Converters, LDOs, etc.
5. Experience of Battery charger design, fuel gauge, analogue sensor instrumentation; protection circuits.
6. Hand-on experience in hardware implementation of embedded system data communication protocols such as 1-wire, I2C, SPI, UART, USB.
7. Experience of BDC/ BLDC or steppers motors, motor drive circuit design and
its working principles.
8. Diverse experience in microcontroller/ microprocessor based circuit design and bring-up.
Ideally from ST/ TI/ NXP/ Renesas and sensor interface on PCB assembly level.
9. Ability to design and implement smart sensors , sensors instrumentation like current, voltage signal conditioning, Time-of-Flight, Proximity, Position, ALS, etc on a PCB assembly level.
10. Knowledge about Design calculations/Documentation during Product Development Life
Cycle milestones.
11.Knowledge of EMI- EMC and ESD standards and practices is a plus

Good to have:
1. Strong communication and documentation skills and ability to operate independently.
2. Experience with RTOS
3. Experience with ESP32 and ESP-IDF .
4. Experience with portable, battery operated designs and power budgeting.
5. Knowledge about Wi-fi, Bluetooth, BLE, RF Antenna design Technologies is a plus.
6. Experience of Microphone and Speaker circuit design is a plus
7. Familiar with PCB fabrication technologies, Rigid-Flex PCBs, Flex Cables.
8. Hand-on experience of manufacturing process including DFM and DFT for consumer
products at scale.
9. Familiar with MIPI Camera CSI and DSI interface implementation ; display Modules and their communication protocols; Audio signal processing interface.