Two equipment in site but equipment in between goes to pipe centre fw welding after complete how to the hydrotest?

Question

Accepted Answer

The hydrotest can be conducted after completing the welding of the pipe center fw.

Ensure that the equipment on both ends of the pipe are ready for the hydrotest.
Isolate the section of the pipe where the welding was done using blinds or spectacle blinds.
Connect the hydrotest pump to one end of the pipe and fill it with water.
Increase the pressure gradually to the required test pressure and hold it for the specified duration.
Inspect the pipe for any leaks or abnormalities during the test.
If the test is successful, drain the water and remove the blinds to complete the installation.

Accepted Answer

That's one is golden joint

Popular interview questions of Piping Supervisor