Tell about oil and gas static equipment anyone equipment inspection services and function of the internal parts

Question

Accepted Answer

Oil and gas static equipment inspection services involve examining the internal parts and ensuring their proper functioning.

Oil and gas static equipment refers to stationary equipment used in the oil and gas industry, such as storage tanks, pressure vessels, and heat exchangers.
Inspection services involve thorough examination of the internal parts of the equipment to check for any defects, corrosion, or damage.
The function of internal parts varies depending on the equipment. For example, in a storage tank, the internal parts may include the tank shell, roof, and bottom plates, while in a pressure vessel, they may include the shell, heads, and nozzles.
Inspectors ensure that the internal parts are in good condition, properly installed, and meet the required standards and specifications.
They also check for proper functioning of components such as valves, gauges, and safety devices.
Inspections help identify potential risks, prevent equipment failures, and ensure the safety and efficiency of oil and gas operations.

Accepted Answer

The static equipment anyone ; pressure vessels ( drums,columns,reactors and filters.) And the heat exchangers (she'll and tubes,plate and frame,air coolers.

Accepted Answer

Pressure vessel vertical and horizontal

Heat exchanger

Tank

Valve

Falange

Coulm

Shell type Heat exchanger

Plate type Heat exchanger

Accepted Answer

Pressure vessels, drums, columns, reactor, filters and heat exchanger.

ii) Shell and tube, pate frame, air cooler

Accepted Answer

The majority of mechanical equipment found in oil and gas facilities belongs the static equipment group which comprises pressure vessel (drums, columns, rector filters) and heat exchanger (shell and tubes, plate and frame, air coolers).

This article will contain cost effective recommendation for design material and fabrication. They aim to enable the inspector/surveyors/engineer/purchaser who is not an equipment specialist to check that economical choice are made.

The specification and selection of the equipment is responsibility of static equipment engineer base on requirement specified by others disciplines, including process, material and plant layout.

. Service (type of fluid)

. Special service (hydrogen, sour, cycle lethal)

. Presence of chlorides

. Vessel orientation (vertical/horizontal)