VTL/VMC Operator

JOB Description - WIL

Area or Department

Aerospace

Position

VTL

Qualification (Mandatory)

ITI Tuner/Machinist

Qualification (Desirable)

A well experienced candidate for operating VTL Machine.

Experience

Above 5 years

Age

Below 42 years

Technical Skill set (Good to have)

1. Drawing/Blue print Reading 2. Knowledge of various measuring Instruments (Dial Indicator, Micrometer, Vernier PIE tape etc.) 3. Precision Measurements 4. Machine Tools 5. Quality checks 6. VTL operations 7. CNC codes 2. CNC 2D programming.

Special Skills

1 Advance CNC programming 2. Tolerance analysis 3. Fixture design 4. Machine Maintenance

Soft skills (Must have)

Experience of working on VTL having Chuck Diameter more than 1 meter.

Soft skills (Good to have)

Able to speak ( Marathi/Hindi/English)

Job Description

• Follow detailed instructions, prescribed procedures, drawings and operation sheets, specifications and other written or oral instructions.

• Set up jobs without direct assistance, properly nesting work in chuck to obtain squareness and parallelism of subsequent bores and faces.

• On set-ups that are more involved, receive assistance and instruction.

• Perform rough and finish Boring, OD, ID, Taper turning, profile machining and similar lathe operations confined to established machining procedures that are usually routine or repetitive in nature.

• Maintain close tolerances where dimensional requirements are incorporated in tooling.

• Set and maintain feeds and speeds as prescribed.

• Check work visually and with precision measuring instruments and record data manually or electronically as required.

• Remove and replace dull or defective tools and make minor machine adjustments to maintain specifications and quality of work.

• Block, clamp, and shim to hold and align work piece and prevent springing, distortion or breakage.

• Perform similar or related operations as directed by working leader or supervision.

• Perform other related work of a comparable or lower skill level, including deburring, polishing and part marking.

• Refer questionable conditions or recurring difficulties to working leader or supervision.

• Perform operator checklist as required and comply with all EH&S procedures.

• As required segregate waste material and follow good housekeeping practices.

• May be assigned to carry out tasks, not specifically listed, within the scope and skill level of this job description in support of department objectives and to develop individuals skills.

Accommodation : Non Chargeable basis in company quarters.